2-27. SOLENOID VALVE REPLACEMENT/REPAIR (CONT)
Place drip pan under solenoid valve.
To prevent electric shock, make sure battery is disconnected before performing this procedure.
Tag two wires. Remove two nuts, lockwashers, and wires.
For raw water pump assembly: Loosen two hose clamps.
For boost pump assembly: Loosen two fuel lines.
Tag and disconnect fuel lines.
Remove two mounting screws and flatwashers. Remove valve.
For raw water pump assembly: Remove two hose fittings from valve.
Remove screw, washer, and nameplate from coil assembly.
Remove coil assembly.
Remove nut, tube core assemblies, and gasket from body.