4-25. LOW PRESSURE WATER TUBING. This task covers:
Tools, see Appx B, Sec Ill, Ref Code (No.):
Tool Kit, General Mechanics Automotive (1)
Tape, Antiseize (Appx E, Sec II, Item 67)
Ties, Wire (Appx E, Sec II, Item 71)
Banding and Clamps (TM 10-4610-232-24P)
Preformed Packings (TM 10-4610-232-24P)
Wire ties removed
Be sure all pressure is released before working on any component. However, low
pressure water tubing must be under pressure while checking for leaks in the
system. If leaks are observed, repair is required.
This procedure is applicable to all inlet and outlet tubing and hoses.
When removing more than one low pressure tube and/or hose at a time, tag the
clamps and hoses to simplify installation.
Check for leaks and repair as required.
Figure 4-27. Low Pressure Water Tubing