TM 10-4610-232-34
m. Refer to Figure 2-35 and disassemble motor starters MS7 and MS3 as follows:
(1) Loosen two screws (1) and remove jumper (2).
(2) Loosen captive screws (3), press down and snap out auxiliary contacts (4 and 5).
(3) Remove four captive screws (3) and remove coil cover (6).
(4) Remove coil (7) and pole piece (8). Remove pole piece (8) from coil (7).
(5) Loosen two captive screws (9) and remove contact cover (1 O).
(6) Remove contact assembly (11 ) and press down on moveable contacts (12) and remove springs (13) and
contacts (1 1),
(7) Remove screws (14) and overload heater (15).
Figure 2-35. Motor Starters MS7 and MS3
n. Refer to Figure 2-36 and disassemble motor starter MS8-2S as follows:
(1) Loosen captive screws (1). Press down and snap out auxiliary contacts (2).
(2) Remove four captive screws (1) and remove coil cover (3),
(3) Remove coil (4) and pole piece (5).
2-139