• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Table 3-1. Compressor Clearance Tolerance Limits
HIGH PRESSURE PUMP MOTOR

TM-10-4610-232-34 Water Purification Unit Reverse Osmosis 3 000 GPH Trailer Mounted Flatbed Cargo 22-1/2 Ton 8 Wheel Tandem Model No. WTA-060 Manual
Page Navigation
  293    294    295    296    297  298  299    300    301    302    303  
TM   10-4610-232-34 NOTE Install inner race bearings in one continuous motion. Do not stop. g. Install the inner races of bearings (13 and 14) on crankshaft, being careful to slide the heated races into their final position. h. Install the outer race of bearing (13) in crankcase (31). i. Install the outer race of bearing (14) in end cover (11). NOTE When installing crankshaft assembly, position the connecting rods so that the front rod, when viewed from the open end of the crankcase, is in the center cylinder opening. The rear connecting rod goes through the large right hand opening and the middle rod goes through the small left hand opening. j. Install the assembled crankshaft assembly in crankcase (31) being careful not to allow the connecting rods to bump against the crankcase. k. Block the crankshaft assembly so it can not fall, then install preformed packing (12) and seal (16) in cover (11). CAUTION When installing cover, be careful not to damage seal. l. Install cover (11) with the stamped number down and install washers (10) and capscrews (9). Make sure the crankshaft rotates freely by hand. m. Install seal (15) in the bore of crankcase (31). n. Install pulley (8), tensioning piece (7), flange (6) and secure with capscrews (5). o. Install roll pin (4), sheave (3), washer (2) and secure with socket head screw (1). 3-12







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.