AIRBRAKE INSTALLATION MAINTENANCE (MODEL WPES-1) - continued.
Remove nut (30) from loop clamp(s) (29).
Open loop clamp (29) and remove from stud (28) and attached hose/tube.
Tag and disconnect tubing (31) from tee (32) and remove tee.
Tag and disconnect opposite end of tubing (31) and remove tubing.
Disconnect and remove hoses (33 and 34).
The following procedures describe installation of airbrake components used throughout the brake
installation. Removal of one of each type part is shown. Removal of other like parts is similar.
Apply anti-seize tape to male fittings. Be sure to wrap tape in same direction as pipe thread.
Position and connect hoses (33 and 34).
Position tubing (31) and connect one end as tagged during removal.
Connect opposite ends of tubing (31) to tee (32).
Position loop clamp (29) around attaching hose/tube and position on stud (28).
Install nut (30) on stud (28).