ELECTRICAL INSTALLATION MAINTENANCE - continued.
Refer to wiring diagram in Appendix F for cable assembly being repaired.
Slide insulator bushing (2) and coupling (6) over terminals (7) and wires (1)
Using soldering gun, solder wires (1) to terminal (7) as tagged Remove tags.
Screw coupling (6) to shell (8).
Tighten screws (3) securing clamp (5) to cable assembly (4).
The following tests are performed to determine if the cable assembly is defective. Before
testing, cable assembly must be disconnected. Failure to disconnect cable can result in
Make sure wire terminals are not touching each other.
Refer to wiring diagram in Appendix F for cable assembly being tested.
If continuity does not exist between any two points, replace damaged or faulty wire.