MOTOR (CHEMICAL FEED PUMP) MAINTENANCE - continued.
Position capacitor (5) on stator assembly (21) and connect wiring as tagged during disassembly.
Install gasket (6), cover (7) and two screws (8) on stator assembly (21).
Position wiring through hole in conduit box (12), install conduit box with two screws (13), then connect wiring
(14) as tagged.
Install gasket (11), cover (10) and two screws (9) on conduit box (12).
Install thrust washer (19) and wavy washer (20) on shaft of rotor (17).
Stator assembly wiring can be damaged by rotor or rotor shaft if rotor is
not installed carefully.
Install rotor (17) in stator assembly (21). Make sure bearing (15) seats properly in and cap (1).