3-40. PUMP AND MOTOR STAND MAINTENANCE - continued.
Drycleaning solvent P-D-680 is highly toxic and can ignite organic materials,
nitrates, carbides, and chlorates. Wear eye, skin, and respiratory protection Use
in a well-ventilated area
Using drycleaning solvent, clean stand Dry with wiping rag.
Using wire brush, clean rust and corrosion from stand.
Inspect stand (10) for cracks and damage.
Inspect mounting hardware for excessive wear or other damage
Inspect plate adapters (3 and 4) and mounting plate (5) for cracks and corrosion
Replace defective components
For welding procedures refer to TM 9-237.
Install mounting plate (5) on stand (10) with four screws (6), washers (7), lockwashers (14), and nuts (13)
Install screw (9), nut (8), two pins (11), and washers (12).
Install washer (18) and pin (17) on bolt (9).
Install plate adapters (3 and 4) using four lockwashers (2), and nuts (1).
Using chain hoist, position stand (10) on ROWPU frame
Install ten lockwashers (15), screws (16), and washers (15).