3-45. CONTROL BOX ASSEMBLY MAINTENANCE - continued.
There are nine lampholders. All are installed the same. One is shown.
Remove 14 screws (3), lockwashers (2), and flat washers (1). Lower control box cover (4).
Install bulb (11), flange (10), and lens (12). Allow about 1/8 inch between flange and lens.
From the front of control box assembly (7), install rubber washer (8) and lampholder (9).
Install new lockwasher (6) and nut (5).
Install three wires (13) as tagged and two screws (14).
Install control box cover (4) and install but do not tighten 14 screws (3), lockwashers (2), and flat washers (1).