3-45. CONTROL BOX ASSEMBLY MAINTENANCE - continued.
If working on control box assembly, remove 14 screws (4), lockwashers (3), and flat washers (2). Lower
control box cover (1).
Position terminal board (5) in place and aline mounting holes.
At each end of terminal board (5), install two screws (6), flat washers (7), new lockwashers (8), and nuts (9)
Position terminal link (12) and wires (13) as tagged and install screws (14).
If working on junction box assembly, close junction box cover (10) and secure 13 rotary fasteners (11).
If working on control box assembly, install control box cover (1). Install but do not tighten 14 screws (4),
lockwashers (3), and flat washers (2).