2-17. PREPARATION FOR MOVEMENT - cont.
Stow accessories. (Applies to Models H-9518-1, H-9518-2, and H-9518-3 only.) Refer to figure 2-24a and
stow accessories as follows:
To prevent damage to R.O. elements, elements must not be stored or exposed to freezing
If ROWPU will be placed in administrative storage or subject to freezing temperatures, remove R.O.
elements (para. 3-4) and store in boxes supplied with the unit.
Pack loose components in storage chests. Refer to loading plans on storage chest lids for position and
quantity of components within each chest.
First Layer (bottom)
Some accessories are heavy/difficult to handle. To prevent injury to personnel and
damage to the equipment, four personnel are required to lift the backwash pump onto the
ROWPU frame. Two personnel are required to lift the raw water pumps and distribution
Stow raw water pumps No. 1 and No. 2 (6 and 7) and secure to floor of ROWPU with hold down
Stow backwash pump (9) and secure to floor of ROWPU with hold down straps.
Stow suction hoses (4) behind raw water pumps (6 and 7).
Stow canvas discharge hoses (5 and 8) between multimedia filter and raw water pumps (6 and 7).
Stow four utility pails (10), R.O. Element Tool ( 11), Paddle (12) and Sledge Hammer (13) on floor
next to backwash pump (9).
Stow two water tanks (14 and 15) between cartridge filter and R.O. Pump.
Second Layer (middle)
Stow the two storage chest ( 16 and 17) on top of the raw water pumps (6 and 7)
Stow the wellpoint assembly (18) and stakes (19) on top of the backwash pump (9).
Stow the float next to the multimedia filter (20).
Stow the deionization cartridges (22) on top of the R.O. pump.
Stow a water tank (21) next to the cartridge filter.
Third Layer (Top)
Stow suction hoses (4 and 23) on top of the deionization cartridges (22) and the storage chests (16 and
2-142 Change 2