2-80. LIGHT ASSEMBLY REPAIR (WPES-10 AND H-9518-1) - continued.
There are two composite light assemblies on the flatbed cargo trailer. Both are repaired
the same. One is shown. the other is similar.
Loosen six captive screws (9) and remove door ( 10) and preformed packing (11).
There are three types of bulbs in light assembly. Note bulb type as you remove bulb
from each socket.
Remove four bulbs ( 12).
Remove lenses ( 13) from door (10).
Using clean water and detergent, wash door (10), body (15) and three lenses (13).
Rinse parts in clean water and dry with wiping rags.
Using sandpaper, remove corrosion from lamp sockets as required.
Inspect for cracked, broken, and leaking lenses ( 13), cracked and bent door (10) and damaged heads and
threads on screws (9).
Inspect body ( 15) for cracks and broken lamp sockets and burned, brittle, or cut wires on cable (6).
Inspect bulbs ( 12) for cracks and loose and deformed bases and burned filaments.
Inspect lamp sockets (14) for corrosion.
Replace lo&washers, packing and gaskets.
Replace defective components.
2-314 Change 1