2-80. LIGHT ASSEMBLY REPAIR (WPES-10 AND H-9518-1) - continued.
There are two light assemblies on the flatbed cargo trailer. Both are installed the same.
One is shown, the other is similar.
Position light assembly (8) on trailer (5). Install two lo&washers (7) and screws (6).
Pull cable (4) through hole in chassis (5) and slip grommet (3) onto end of cable.
Work grommet (3) into grommet hole in chassis (5).
Failure to match wires as marked will cause electrical malfunctions. Be sure to connect
wires as labeled during removal.
Match halves of four connectors (1) as marked during diassembly. Push matching halves together until
Push four connectors (1) into spring clips (2).
2-316 Change 1