3-57. WIRING HARNESS, W6, W7, W8, W9 (EXTERNAL PUMPS) REPAIR.
This task consists of:
General Mechanics Tool Kit (Appendix B, Section III, Item 4)
Multimeter (Appendix B, Section III, Item 3)
Refer to TM 43-0158/TO 1-1A-15 (Air Force) for Tools required to repair Cable Assembly.
Material Parts Required
Lockwashers (TM 10-4610-241-24P)
Tiedown Straps (TM 10-4610-241 -24P)
Refer to TM 43-0158/TO 1-1A-15 (Air Force) for Materials/Parts required to repair Cable Assembly.
Junction Box removed from ROWPU and Cover open (Paragraph 3-53).
This procedure covers removal of wiring harness W7. Wiring harnesses W6, W8 and
W9 are removed in a similar manner.
Disconnect wires (2) by removing screws (1) at termination points B (see table, opposite page).
Remove four nuts (3), lockwashers (4), flatwashers (5) screws (6) and cap (7).
Remove tiedown straps (8) as necessary to release harness (9) from clamps (15) and other wiring.
Remove wiring harness (9) and gasket (10) from junction box (16).
As required, remove nuts (11), lockwashers (12), flatwashers (13). screws (14) and clamps (15).
Clean wiring harness with a damp rag and allow to dry.
Inspect wiring harness in accordance with TM 43-0158/TO 1-1A-15 (Air Force).