TM 10-4610-241-24
TO 40W4-13-42
3-66. BRAKE ASSEMBLY REPAIR (MODELS WPES-10 AND H-9518-1) - continued.
e.
Installation.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
Using brass drift pin, tap spider bushing (24) into spider (20).
Position spider (20) on flange of axle (29) and install with eight screws (14), lockwashers (13) and nuts
(12).
CAUTION
Push camshaft straight in. Any vertical or side-to-side movement can cause damage to
splines.
Position washer (22) and packing (21) on shaft (23) and feed shaft thru bushing (24) in spider (20).
Position seal (19), spacer (18), snapring (17), housing half (16) and preformed packing
(15) on camshaft (23).
Feed camshaft (23) thru mounting plate (28).
Position seal (19) and spacer (18) on spider (20) and install snapring (17).
Position bushing (11), packing (10) and housing half (9) on camshaft (23).
Aline mounting holes in housing halves (9 and 16) with holes in mounting plate (27) and install four
screws (8), lockwashers (7) and nuts (6).
Install slack adjuster (5) and secure with snapring (4).
Install grease fittings (25.26 and 27).
Using grease gun, lubricate spider (20), slack adjuster (5) and bushing (11) in accordance with LO
10-4610-241-12.
Connect clevis (3) to slack adjuster with pin (2) and cotter pin (1).
Adjust brakes in accordance with Paragraph 2-88.
3-366 Change 1