• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
MAINTENANCE FUNCTIONS - TM-10-4610-244-13_92
EXPLANATION OF COLUMNS IN REMARKS, SECTION IV

TM-10-4610-244-13 Hypochlorination Unit NSN 4610-01-364-4485 Model AHY001 Manual
Page Navigation
  79    80    81    82    83  84  85    86    87    88    89  
TM 10-4610-244-13 TM 09476B-13/1 B-3.  EXPLANATION OF COLUMNS IN THE MAC, SECTION II (Cont'd). d.     Column  4,  Maintenance  Category.    Column  4  specifies,  by  the  listing  of  a  work  time  figure  in  the  appropriate subcolumn(s), the category of maintenance authorized to perform the function listed in Column 3.  This figure represents the active time required, in hours, to perform that maintenance function at the Indicated category of maintenance.  If the number  or  complexity  of  the  tasks  within  the  listed  maintenance  function  vary  at  different  maintenance  categories, appropriate  work  time  figures  will  be  shown  for  each  category.    The  work  time  figure  represents  the  average  time required to restore an item (assembly, subassembly, component, module, end item, or system) to a serviceable condition under     typical     field     operating     conditions.          This     time     includes     preparation     time     (including     any     necessary disassembly/assembly time), troubleshooting/fault location time, and quality assurance/quality control time in addition to the  time  required  to  perform  the  specific  tasks  identified  for  the  maintenance  functions  authorized  in  the  maintenance allocation chart.  The symbol designations for the various maintenance categories are as follows: C........Operator or crew O .......Unit Maintenance F ........Direct Support Maintenance H........General Support Maintenance D........Depot Maintenance e.  Column  5,  Tools  and  Equipment.    Column  5  specifies,  by  code,  those  common  tool  sets  (not  individual  tools)  and special tools, TNMDE, and support equipment required to perform the designated function. f.  Column 6, Remarks Column 6 shall, when applicable, contain a letter code, in alphabetic order, which shall be keyed to the remarks contained in Section IV. B-4.  EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIIREMENTS, SECTION III. a.  Column 1, Reference Code.  The tool and test equipment reference code correlates with a code used in the MAC, Section II, Column 5. b.  Column 2, Maintenance Category.  The lowest category of maintenance authorized to use the tool or test equipment. c.  Column 3, Nomenclature.  Name or Identification of the tool or test equipment. d.  Column 4, National Stock Number.  The National stock number of the tool or test equipment. e.  Column 5, Tool Number.  The manufacturer's part number. B-3







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.