CONTROL PANEL - Continued.
Repair - Continued.
(2) Start Burner Switch, S-1.
(a) Loosen two screws at rear of switch (10).
(b) Tag and disconnect wiring from rear of switch (10).
(c) Turn push button 1/8 turn counterclockwise and remove
(d) Remove switch (10) from panel (11).
(e) Install a new switch.
(f) Install switch (10) into position and install marker (12).
(g) Tighten both screws on rear of the switch (10).
(h) Connect wiring to new switch (10) per tagged identifica-
(3) Indicator Light Holder, L1.
(a) Tag and disconnect wiring from rear of holder (9).
(b) Loosen two screws on rear of holder (9).
(c) Turn lens (13) 1/8 turn counterclockwise and pull from
(d) Remove lamp (14).
(e) Remove holder (9).
(f) Replace defective parts.
(g) Install holder (9) into position.
Install lamp (14) and lens (13).