(i) Tighten two screws on rear of holder (9).
Connect wiring per tagged identification.
(4) Thermostat Selector Switch, S-2.
Tag and disconnect wiring from the rear of switch (15).
Loosen two screws on rear of switch (15).
Remove knob (16) by turning collar 1/8 turn counterclock-
wise and pull from front of switch (15). Replace broken
Assemble by placing switch (15) into position and tighten
both screws on rear of switch (15).
Connect wiring to rear of switch per tagged identification.
Install knob (16) and tighten setscrew.