Drycleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel and property.
Wear chemical resistant gloves when using solvents, and avoid repeated or prolonged skin contact.
Do not use near open flame or excessive heat. Flash point of solvent is 100 degrees F to 138
degrees F (38 degrees C to 59 degrees C).
Clean all metal parts with a cloth dampened with drycleaning solvent.
(2) Dry thoroughly.
Speed reducer drive pulley
Lockwasher, ext, tooth 5/16
ini. (8 reqd)
Slurry feeder drive motor
Chemical feed equipment frame
Motor drive pulley
Capscrew, hex., 5/16-18 x
in. (4 reqd)
Figure 3-10. Chemical Slurry Feeder Drive Motor.