Rear mounting angle bracket
Capscrew, hex, 5/8-11 x 2 in.
Nut, plain, hex, 5/8-11
Wood block (brace) (2 reqd)
Washer, lock, split type,
med, 5/8 in.
Figure 4-19. Van Body Rear Mounting.
Position wood rail (3, fig. 4-18) between center and rear mounting plates (5) and secure each side of
the center and rear of the body to truck frame with bolts (4) and washers (6).
Position a wood block (5, fig. 4-19) on each side between tile rear angle brackets (1) and secure the
rear of the body to the truck frame with screws (4), washers (3), and nuts (2).
Connecting heater fuel line and electric wiring.
Connect the fuel line and the electric connections to the personnel heater.
Connect the 24-volt electric system to the truck chassis and connect clearance and blackout lights.
Refer to the wiring diagram (fig. 4-16).