TM 5-4610-223-12
1.
Power cable
9.
Pillow block bearing mount
2.
Cable connector
10.
Wire nut (8 reqd)
3.
Connector nut
11.
Motor lead wires (3 reqd)
4.
Junction box
12.
Screw, machine, 1/4-20 x 1 in.
5.
Pillow block bearing
(4 reqd)
6.
Erdlator agitator drive
13.
Ground wire, hidden
shaft
14.
Power cable lead wires
7.
Drivebelt
15.
Junction box cover
8.
Capscrew, hex, 3/8-16 x
16.
Screw, junction box cover
3/4 in. (4 reqd)
mounting (4 reqd)
Figure 4-35. Erdlator Agitator Drive Motor, Wiring and Belt Removal.
c.
Replace. Repair cracked or frayed wiring insulation by taping. If the motor shows signs of running hot or the
bearings are loose or binding, replace motor. Replace junction box gasket or drivebelt if defective.
NOTE
If the motor is to be replaced, retain the junction box and the pulley and key for installation on the
replacement motor.
4-80