TM 5-4610-223-12
b.
Replace. Replace the assembly if either the motor or pump
c.
Installation of Pump in Frame.
(1)
Position pump in frame (1, fig. 4-97) and install screws (11), washers (13), and nuts (12).
(2)
Attach electric cable (15) to short section of cable attached to electric motor.
(3)
Wrap cable around hose and cable basket (16).
4-114.
RAW WATER OR DISTRIBUTION PUMP PEELER ADJUSTMENT.
a.
General. The peeler (3, fig. 4-98) is located inside the pump in the discharge opening of the pump case. The
peeler is adjustable to control the output of the pump.
1
Jamnut, hex, 1/3-20
3.
Peeler
2.
Setscrew, sp hd, cup point,
4.
Impeller
1/4-20 x 1 in.
Figure 4-98. Peeler, Installation and Adjustment.
4-200