Raw water piping
Flow indicator, FLI-4, 0 to 60 gpm
Raw water inlet
Figure 2-19. Raw Water Flow Indicator, Installed.
When repositioning drivebelt (1), loosen setscrews (5) in two collars (7) and drive pulley setscrew (8).
Move drive pulley to the right or left until belt is aligned with both pulley grooves.
Tighten setscrews (5 and 8) securely and adjust belt tension.
Start agitator drive motor by pressing the erdlator agitator switch START button (6, fig. 2-1) located on front of
electrical cabinet door (20).
Change 1 2-37