INSTALLATION AND ADJUSTMENT
Installation and. adjustment of the vertically mounted
DINGS UNIPAC BRAKE is the same as on the standard
model (this bulletin, pages I thru 3).
FRICTION DISC REPLACEMENT
When replacing friction discs, follow procedure outlined '
on page 1, with this addition:
Care must be taken. to insure proper insertion of
disc separating springs.' Springs are-color coded for
easy identification, and reference is made to spring
color, (see Figure 6 and Table 3)..The installation
order of the disc springs is dependent on brake-
mounting position, (above or below motor), so make
sure to. consult the correct diagram for spring
Figure 6. Vertical Mounting' Brakes
Table 3. Parts for Vertical Mounting
TORQUE: 1-1/2 thru 20 lb. ft
MOTOR FRAMES: 56C, 66C, 143TC, 145TC
HOUSING: All aluminum die cast.
VOLTAGES: All. NEMA single phase voltages and
DUTY: Rated for continuous duty cycle.
MOUNTING: Direct to NEMA "C" motor flanges.
Adapters for larger or smaller frames, foot
mounting, wall mounting, or vertical
mounting, available on request.
HUB MOUNTING: NEMA standard length motor shaft
extensions may be used. Thru shaft
also available with simple cover
The following data should be furnished with your parts
Brake Model Number.
Serial Number if available.
Part Number from Table 2.
Part Description from- Table.
(On hub order, specify bore dia. & keyway
dimensions. On electrical parts, specify voltage,
phase & frequency.)
The Dings Co. has played a principal role in the development and application: of magnetic and power transmission
equipment. A company commitment to design and manufacturing excellence has been a major factor in making Dings
an industry leader. The Dings Co. offers extensive experience plus proven ability in the practical utilization' of magnetic
forces. A worldwide network of sales representatives and distributors provides prompt. and efficient assistance. Dings
is ready to give your problem individual attention.
DINGS - A Tradition of Excellence