• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DO'S AND DON'TS FOR SAFE OPERATION
INSPECTION - TM-55-1930-209-14P-13_134

TM-55-1930-209-14P-13 Water Purification Barges (1930-01-234-2165) Equipment Montoring System Manual
Page Navigation
  105    106    107    108    109  110  111    112    113    114    115  
This  instruction  and  parts  manual  is  provided  as  a  convenience  to  assist  you  in  ordering  repa.  parts  for  your  Chester Zephyr Low Head Room Trolley Hoist. Give all information listed below.  This will enable the factory to promptly fill your order. 1. Provide complete identification data from hoist serial number or nameplate located on the trolley hoist side plate.  In the event identification tags are missing, advise hoist capacity and complete beam size on which it operates. 2. Provide part numbers, description, and quantity required. 3. Provide correct shipping destination. If it becomes necessary to return the complete hoist or certain parts to the factory, authorization is required.  Provide a written explanation for return.  All returns must be made by prepaid freight. CHESTER HOIST DIVISION P.  O.  BOX 229 7573 STATE ROUTE #45 LISBON, OHIIO 44432 Phone: (216) 424-7248 INSTALLATION The hoisting unit is custom sized at the factory to fit on a specific beam size.  Most units are slipped over the end of the supporting rail or beam; however, removable wheels* are provided which enables the unit to be fitted on a beam with obstructed ends. See parts breakdown page 7 for additional information regarding disassembly. The distance between trolley wheel flanges (measured at the tread diameter) should be 118" to 3/16" greater than the beam  flange  width  for  proper  running  clearance.    This  clearance  should  be  checked  before  operating  the  hoist  under load.   The  hoist  should  be  traversed  the  entire  length  of  the  beam  to  check  for  beam  interference  points,  proper  side clearance and effectiveness of the beam stops.  If everything is satisfactory, the procedure should be repeated with a capacity load as a functional installation test. ¶Feature not available on units operating on patented monorail tracks. CHESTER HOIST DIVISION • MONOGRAM INDUSTRIES • PHONE (216) 424-7248 • LISBON, OHIO, U.S.A.  44432 4







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.