2-13.1 Drinking fountain. Troubleshoot according to Chapter IV, Sections II and III in Service Manual: Haws Self-
Contained Electric Water Coolers in Appendix B.
2-13.2 Refrigerator. Troubleshoot according to Troubleshooting and Service Chart in Bailey Model BR-16 Refrigerator
manual in Appendix B.
2-14 Maintenance procedures
When necessary, make sure electrical power and water supply are turned off
before performing maintenance. Observe all safety precautions In this manual and
manufacturers' service manuals/Instructions.
Due to this vessel's mission and crew capabilities, maintenance normally assigned
to higher levels may be assigned to crew members.
2-14.1 Hotplate. Replace indicator light bulb, if defective, with a new bulb.
2-14.2 Drinking fountain
2-14.2.1 Installation. See Section 1, Chapter 1, Service Manual: Haws Self-Contained Electric Water Coolers in
2-14.2.2 Adjustments to drinking water temperature and flow
Drinking water temperature adjustment. Temperature of the drinking water bubbler stream is regulated by a
thermostat in the compressor compartment (Figure 2-4). It is set at the factory to keep the temperature of
drinking water at 50/F. If cooler or warmer water is desired, turn the thermostat adjusting screw clockwise to
lower (to 47/F minimum) and counterclockwise to raise (to 55/F maximum) temperature.
Drinking water flow adjustment. Drinking water bubbler stream is controlled by a pressure regulating valve
(Figure 2-4). Normally, only an initial adjustment is required, but the bubbler stream may be adjusted if desired.
First make sure the drinking water system is operating normally, then remove bubbler button retaining nut to
expose valve adjusting screw. Turn screw clockwise to increase flow and counterclockwise to decrease flow.
2-14.2.3 Maintenance. See Chapter III, Sections I and II in Service Manual: Haws Self-Contained Electric Water Coolers
in Appendix B.
2-14.2.4 Repair. See Sections IV and V in Chapter IV of Service Manual: Haws Self-Contained Electric Water Coolers in
2-14.3.1 Installation. See General Information Section in Bailey Model BR-16 Refrigerator instructions in Appendix B.
2-14.3.2 Maintenance. See Maintenance Section in Bailey Model BR-16 Refrigerator instructions in Appendix B.
2-14.3.3 Repair. See Repair Instructions in Bailey Model BR-16 Refrigerator instructions in Appendix B. Replace light
bulb as needed. Replace defective filter drier when needed. Notify IDS/IGS maintenance unit when refrigerator
performance indicates additional refrigerant is needed.