3-15 Administrative storage. If barge is to be taken out of service for more than 30 days but less than 6 months, barge
remains a unit responsibility and shall be maintained by unit personnel. Prepare for storage and inspect as follows:
Unplug drill press and grinder with dust collector. Tape plug to side of drill press and grinder.
Close jaws on vise.
Clean and secure equipment. Touch up paint if necessary.
Stow loose items.
Check for damage, corrosion, and pilferage at least monthly. Repair as necessary.
3-16 Long-term storage. If barge is to be taken out of service for 6 months or more, turn it in to depot for preparation
and placement into long-term storage. if barge is in administrative storage and is to be taken out of service and placed in
depot long-term storage (6 months or more), process workshop equipment for normal operations as specified below
before releasing to depot:
Perform before operation checks in Appendix C.
Check that equipment operates satisfactorily while performing the procedures in paragraphs 3-8 and 3-9.
Upon successful completion of operation, perform after operation checks in Appendix C.
Release barge to depot for processing into long-term storage.
Section V. Manufacturers' service manuals/instructions
3-17 General. Following list of manufacturers' service manuals/instructions provides additional information on workshop
equipment. A copy of each manual/instructions is in Appendix B. It may be necessary to refer to both these manuals and
the drawings listed in Appendix A while performing procedures in this TM.
Part no. 402-07-651-5009
Power Tool Division
Manual: 17" Variable
400 N. Lexington Avenue
Speed Drill Press
Pittsburgh, PA 15208
Data Sheet 7-B,
FAMCO Machine Division
Belco Industries, Inc.
Kenosha, WI 53140
Grinder with dust collector
No. 275J, Instruction
Baldor Electric Co.
Manual for Baldor
P.O. Box 2400-T
Fort Smith, AR 72902
1 M-132-F, Lincoln
Lincoln Electric Co.
Cleveland, OH 44117