Table 6-2. Preventive Maintenance Checks and Services for Shore Discharge System (Continued)
Q - Quarterly
S - Semiannually
A - Annually
CHECK FOR AND HAVE
IS NOT READY/
REPAIRED OR ADJUSTED
B D A D W M Q S A
Pressure should not exceed 4000 psi.
3) Pump until hand brake piston enters
cylinder and band is tight on brake
4) Position valve SD3 in NEUTRAL posi-
tion (midway between OPEN and
CLOSE position) to lock the cylinder in
the set position.
Check that buoys are in place. Replace if
Check that status signalslights are dis-
Any light is
played as follows on top of deckhouse
Top Signal Middle Signal
Black Diamond Black Ball
Nightime White Light
Roughness on steel chute surfaces could
Check that surfaces are smooth and free of
gouges, damage, or roughness. Repair as
Check fluid level in levelwind reduction
Fluid level low.
gear boxes as follows:
If oil cannot be filled thru breather hole,
Install street elbow In hole to aid In filling.
1) Remove oil level plug in gear box
located on portside of levelwind.
2) Check oil level. Oil level must be near
bottom of oil level plug hole.
3) If Gulf Harmony 43 AW or military
equivalent oil has to be added,
remove breather plug.
4) Fill lowly thru breather hole until oil
begins to drain from oil level plug.
Change 1 6-8