Disassembly and Assembly
Change the position of tool (A) so the compressor
wheel is up as shown.
Put an alignment mark on housing (2) and turbine
housing (3) so that the housing can be put back in the
same position in the turbine housing at assembly.
Remove the bolts, lock plates and clamps that hold
the housing in the turbine housing, and remove the
Put the housing in position on tool (B).
Do not put a side force on the shaft when the
nut is removed.
Use tool (C) and a socket of the correct size to
remove nut (5) from the shaft.
Remove compressor wheel (4) from the shaft.
Remove the housing from the shaft.
10. Remove shroud (6) from the turbine wheel and shaft.