Disassembly and Assembly
5. Install snap ring (3) with tooling (A).
6. Install the bearing and other snap ring.
7. Put ring (4) and sleeve (5) in position in the cartridge.
8. Install bearing (7) with the grooved side up Make an
alignment of the dowels in the housing with the holes in
9. Put spacer (6) in position on the bearing.
10. Put deflector (8) in position as shown.
11. Put seal rings (9) in position on sleeve (10).
12. Install the sleeve in insert (11).
13. Install O-ring seal (12) on the insert.
14. Put insert assembly (13) in position in the cartridge.