Disassembly and Assembly
Timing Gear Cover
Remove Timing Gear Cover 1166-011
remove water pump
remove front support
remove gauge group
remove fuel priming pump and filter
remove crankshaft pulley (3304)
remove vibration damper and pulley (3306)
Remove the bolts that hold the oil pan and oil pan
plate to the timing gear cover Loosen the remainder of
the bolts that hold the oil pan In position. Put spacers
between the block and the oil pan plate gasket to hold
the gasket away from the timing gear cover. If the
gasket is damaged, remove the oil pan plate. See
Remove And Install Oil Pan Plate.
Remove covers (1) and (2) from the back side of the
timing gear plate.
Remove the two bolts and clamp from location (X)
that hold the crankshaft front seal adapter in position.
Remove the crankshaft front seal adapter and front seal
from the engine as a unit.
Remove all bolts (3) that hold the timing gear cover
in position on the engine. Remove timing gear cover (4)
and the gasket from the engine.
Install Timing Gear Cover 1166-012
Put the gasket and timing gear cover (1) in position
on the engine, and install the bolts that hold it. Tighten
the two bolts at location (X) to a torque of 23 + 4 Nm.(17
+ 3 Ib.ft.).
Put the crankshaft front seal adapter and seal in
position in the timing gear cover, and install the clamp
that holds it.