LUBRICATION ORDER
LO 10-4610-232-12
14 February 1996
Supersedes LO 10-4610-232-12, 11 April 1991
WATER PURIFICATION UNIT REVERSE OSMOSIS, 3,000 GPH TRAILER MOUNTED, FLATBED CARGO, 22 1/2
TON, 8 WHEEL TANDEM MODEL NUMBERS WTA-060, NSN 4610-01-219-8707 AND ROWPU-1, NSN 4610-01-371-
1790 Reference TM 10-4610-232-12
DISTRIBUTION STATEMENT A: Approved for public release; distribution is unlimited.
Hard time intervals and the related task-hour times are based on normal operation. The task-hour time specified is the
time you need to do all the services prescribed for a particular interval or if you are operating the equipment under adverse
operating conditions, including longer-than-usual operating hours. The interval may be extended during periods of low
activity if extended adequate preservation precautions must be taken.
On-condition (OC) intervals for oil changes, shall be determined by the Army Oil Analysis Program (AOAP) laboratory and
shall be applied unless otherwise notified
Hard time of change intervals will be applied in the event AOAP laboratory support is not available.
The time specified is the time required to perform all services at particular interval (on-condition or hard times).
Lubricate points indicated by dotted arrow shaft on both sides of equipment. Clean parts with dry cleaning SOLVENT. Dry
before lubricating. Drain crankcase when HOT Fill and check level. The lowest level of maintenance authorized to
lubricate a point is indicated by one of the following: (C) Operator/crew, or (O) Organizational Maintenance.
You can help improve this technical manual. If you f, , any mistakes or if you know of a way to improve the procedures,
please let us know. Mail your letter or DA Form 2028 ,Recommended Changes to Publications and Blank Forms) directly
to: Commander, US Army Aviation and Troop Command, ATTN: AMSAT-I-MP, 4300 Goodfellow Blvd., St Louis, MO
63120-1798 You may also submit your recommended changes by E-Mail directly to <daf2028@st.louis-tmh7.army.mil> A
reply will be furnished to you.
LUBRICANT INTERVAL
INTERVAL LUBRICANT
Compressor Oil
High Pressure
Sump
Pump Crankcase
(Drain and Refill)
(O) (See Note 3)
(O) (See Note 4
High Pressure
Pump Sight Gage
Compressor Oil
(C) (Check Level)
Level Gage
(Check Level)
(C) (See Note 4)
High Pressure
Pump Motor
(C) (Grease Fittings)
Door Hinges
Latch Assembly
(Lubricant)
(C) (Lubricant)
(C)(Use MIL-G-23827)
Door Hinges
(Lubricant)
(C) (Use MIL-G-23827)
CACard 1 of3
RD 1 OF 3
