TM 10-4610-215-24
TM 08580A-24/2
f. Repair or Replace.
(1) Replace all hose clamps.
(2) Replace damaged water or oil hoses.
(3) Replace damaged grommets and O-rings,
(4) Replace all damaged screws, nuts, bolts, and washers.
(5) Threaded inserts may be removed, retaped, and replaced. Severely damaged inserts maybe
removed, the tapped hole welded closed, and a new insert installed.
(6) Repaint, as needed, in accordance with Standard Operating Procedures.
g. Installation. (Figure 2-46)
(1) Install nut (21) on adjusting bolt (20).
(2) Seat nut (21) at end of threaded portion of bolt (20).
(3) Install adjusting bolt (20) with nut (21) in R.O. pump motor mounting plate (17).
(4) Install flat washer (18) and groove pin (19) in adjusting bolt (20).
(5) Place R.O. pump motor mounting plate (17) with adjusting bolt (20) attached on stand (11).
(6) Align mounting holes in mounting plate (17) with stand (11) mounting holes.
(7) Install four bolts (1 4), four flat washers (15), and four lockwashers (16) into R.O. pump motor mounting
plate (17) and stand (11).
(8) Install flat washer (13) and groove pin (12) into adjusting bolt (20).
(9) Place stand (11) on ROWPU frame and align mounting holes.
(10) Install ten bolts (9) and ten lockwashers (10) into R.O. pump mounting stand (11) and ROWPU frame.
(11) Install protective grommet (8) in hole in stand (11).
(12) Slip oil drain hose (7) through hole in grommet (8).
(13) Pull approximately two feet of oil drain hose (7) through grommet (8).
(14) Install protective grommet (6) in hole in stand (11).
(15) Slip water drain hose (5) through hole in grommet (6).
(16) Pull approximately two feet of water drain hose (5) through grommet (6).
(17) Install three clamps (4) on water drain hose (5) and two clamps (4) on oil drain hose (7).
(18) Install three screws (2) and three lockwashers (3) on clamps (4) and secure water hose (5) and oil
hose (7) to stand (11).
(19) Install two hose clamps (1) on water drain hose (5) and oil drain hose (7).
h. R.O. Pump Assembly Installation.
(1) Install R.O. pump assembly in accordance with paragraph 2-73.
(2) Install R.O. pump motor in accordance with paragraph 2-47.
(3) Install R.O. pump pulley sheave in accordance with paragraph 2-77.
(4) Install R.O. pump belts in accordance with paragraph 2-76.
(5) Install R.O. pump belt shroud in accordance with paragraph 2-75.
2-85
