TM 10-4610-215-24
TM 08580A-24/2
f. Installation. (Figure 2-51)
(1) Install input pipe (25) in booster pump (20).
WARNING
ELECTRICAL HIGH VOLTAGE
Electricity can cause serious injury or death. Be certain that all
power is removed before performing maintenance on electrical
equipment.
(2) Place booster pump approximately in its mounting loation and carefully turn it on its side to expose
conduit box (24).
(3)
(4)
(5)
box (24).
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
NOTE
If conduit box cover is in place, remove four screws (8), (figure
2-51 ), conduit box cover (9), and gasket (10) from conduit box
(24).
Slip cable grip (19) over cable.
Insert tagged wires through hole in conduit box (24).
From inside conduit box (24), slip cable grip nut (18) over wires and mount cable grip (19) to conduit
Slip tagged wire lugs (16) over screws (17) on each set of wires.
Install flat washer (15), lockwasher (14), and nut (13) on screw (17) for each set of wires.
Remove tags.
Wrap each screw and wire lug assembly with tape (12).
Using twine (11), tie wires into bundle.
Carefully compress wire bundle into back of conduit box (24).
Hold conduit box cover (9) and gasket (10) in place.
Install four screws (8) into conduit box cover (9), cover gasket (10), and conduit box (24).
Place spacer plate (21) in its mounting location on the ROWPU frame (22).
Place booster pump (20) in its mounting position on the spacer plate (21).
Align mounting holes in ROWPU frame (22), spacer plate (21), and booster pump (20).
Install four bolts (6) and four lockwashers (7) in booster pump (20), spacer plate (21), and frame (22).
NOTE
Do not tighten mounting bolts yet.
Slip two hose clamps (5) over hose (4).
Connect hose (4) to pump (20).
Slide hose clamp (5) over output pipe of booster pump and tighten.
Install pipe unit (3) to input pipe (25) of booster pump (20).
Tighten four mounting bolts (6).
Install cable clamp to frame (22) using screw (1) and flat washer (2).
2-99
