TM 10-4610-215-24
TM 08580A-24/2
(15) Remove gasket (14) from adapter ring (16).
(16) Remove two screws (15) from adapter ring (16).
(17) Remove adapter ring (16) from splice box (27).
(18) Remove gasket (17) from splice box (27).
(19) Remove two nuts (18), two lockwashers (19), and two flat washers (20) from two bolts (21) holding
splice box (27) to bracket (28).
(20) Remove two bolts (21 ) from splice box (27) and bracket (28).
(21 ) Pull splice box (27) away from bracket (28) enough to expose cable grip assembly, unscrew
compression nut (22), and slide up cable (23).
(22) Remove cable (23) with compression nut (22) and compression fixture (24) from splice box (27).
(23) Remove cable grip nut (25) from splice box (27).
(24) Remove O-ring (26) from cable grip nut (25). Discard O-ring (26).
(25) Remove splice box (27) from bracket (28).
c. Cleaning. Wipe exterior of panel light assembly with a clean cloth.
d. Inspection.
(1) Check that light bulb is not burned out.
(2) Inspect threads of guard, fixture body, adapter ring, and splice box.
(3) Inspect globe for cracks.
(4) Check interior of globe and fixture body for signs of moisture. If there is dirt or moisture inside the
globe, it is a sign that the gaskets are damaged and must be replaced.
(5) Discard all gaskets.
(6) Inspect ceramic socket for chips or cracks.
(7) Inspect hardware for damage or corrosion.
(8) Inspect electrical contacts for corrosion.
e. Repair or Redate.
(1) Replace bulb, if necessary.
(2) Replace all O–rings, gaskets, and damaged hardware.
(3) Replace ceramic sockets if unserviceable.
(4) Replace globe, if cracked.
f. Installation. (Figure 2-75)
(1) Slide compression nut (22) down cable (23).
(2) Slide compression fixture (24) down cable (23).
(3) Install cable grip nut (25) and O-ring (26) in splice box (27).
(4) Pull wire through cable grip nut (25) and feed through hole in splice box (27).
(5) Slide compression fixture (24) and compression nut (22) up cable (23) to cable grip nut (25).
(6) Connect compression nut (22) to cable grip nut (25).
(7) Hold splice box (27) in place.
(8) Insert two screws (21 ) through mounting bracket (28) and splice box (27).
(9) Install two flat washers (20), two lockwashers (19), and two nuts (18) on screw (21).
2-147
