TM 10-4610-215-24
TM 08580A-24/2
(7) Remove outer tube assembly (20).
(8) Remove seal (21) from outer tube assembly (20).
(9) Remove spring pins (22) and nut (23).
(10) Remove nut (24), ground pad cup (25), and ground pad (26) from inner tube (27).
d. Assembly.
(1) Position ground bad (26) to inner tube (27) and install ground pad cup (25) and nut (24).
(2) Install nut (23) and spring pins (22).
(3) Install seal (21) in outer tube assembly (20).
(4) Position outer tube assembly (20) over inner tube (27).
(5) Install seal (19), key (18), cover (17), and screws (16).
(6) Install spring pin (15) and screw (14).
(7) Place thrust collar (13) and gear (12) on screw (14). Install spring pin (11).
(8) Install pinion (10), thrust washer (9), and bushing (8), pushing pinion (10) into thrust collar (13) with
bushing (8).
(9) Make four revolutions of pinion (10) to ensure that there is no binding or interferences.
(10) Align hole in bushing (8) with hole in outer tube assembly (20) and install grooved pin (4).
(11) Install spring (7), latch (6), and spring pin (5).
(12) Install bearing (3).
(13) Position gear housing cover (2) on outer tube assembly (20) and install screws (1).
e. Installation. Refer to paragraph 2-23 for installation of leveling jacks.
3-44. TRAILER SWIVEL ASSEMBLIES. (ARMY)
a. General. The trailer swivel assemblies secures the leveling jacks and allows them to move in a vertical or
horizontal position. This chapter describes the removal, disassembly, inspection, assembly, and installation of
the trailer swivel assemblies.
3-206
