TM 10-4610-232-12
REPLACEMENT OF RIVETS.
a. Refer to Figure 4-7, View A and drill out remainder of damaged rivet (1), if necessary.
b. Refer to Figure 4-7, View B and place rivet (2) into head of hand riveter (3) and push rivet into hole.
c. Refer to Figure 4-7, View C and squeeze handle until the rivet stem (4) breaks free. This action compresses the
rivet end.
Figure 4-7. Rivets
REPLACEMENT OF TIE MOUNTS.
a. All cable tie mounts on the ROWPU are installed as shown in Figure 4-8. Initial installation is as follows:
(1) Remove paper covering tie mount back (1) and push tie mount against the surface it is to be permanently
attached to.
CAUTION
It is possible to install tie strap (5) backwards. Be sure to position as shown in Figure
4-8.
Figure 4-8. Tie Mounts
4-88
