TM 10-4610-232-12
REMOVAL.
a. Disconnect electrical cable (1, Figure 4-41) at main harness. Cut wire ties (para. 4-10).
b. Loosen nuts (2) and disconnect tubing (para. 4-26).
c. Remove two screws (5), Iockwashers (6) and washers (7) and remove pump (8) and bracket (9). Remove spacers
(10)and(11)
DISASSEMBLY.
a. Remove elbows (4).
b. Remove four screws (12), washer (13), nut (14), Iockwasher (15) and washer (16).
c. Remove pump (8) and four grommets (17) from bracket (9).
a. Replace any damaged or missing hardware or spacers.
b. Replace damaged tube fittings (para. 4-26).
REASSEMBLY.
I
a. Install new grommets(17) and pump (8) on bracket (9) and secure with four screws (12), washers
Iockwashers(15) and washers (16).
b. Install two elbows (4),
13), nuts (14),
a. Position spacers (10 and 11 ) and install pump (8) and bracket (9) on wall of van. Secure with two screws (5),
Iockwashers (6) and washers (7).
b. Connect tubing using nuts (2) (para. 4-26).
C. Connect electrical cable(1) at main harness and install wire ties (para. 4-10).
4-168
