TM 10-4610-232-12
f.
Use antiseize tape on threads of male fittings.
g.
Clean valve (2 and 6) bores if plugged.
REASSEMBLY.
a.
Install adapter (35) on tank and tee (34) on adapter (35).
b.
Install nipple (33) on tee (34).
c.
Install elbow (31) on tee (34).
d.
Install elbow (29) and ferrule (28) on compression nut (27). Install assembled items (27 thru 29) by tightening compression nut
(27) on tank outlet. Elbow (29) must point up as shown.
e.
Install nipple (26) on elbow (29).
NOTE
When installing check valve, be sure the seat is pointing downstream.
f.
Install check valve (25), with arrow down as shown, on nipple (26) and adapter (24) on check valve (25).
g.
Install adapter (22) on tank fitting.
h.
Install tee (21) on adapter (22).
i.
Install elbow (20) and adapter (18) on tee (21).
j.
Install elbow (16) on tank.
k.
Install tubing (15, 17, 19, 23, 30 and 32) as described in para. 2-24.
I.
Install valve (14), fitting (13), and hose (12).
m.
Install valve (2), fitting (11), and hose (10).
n.
If media has been removed, replace as described in s ervice steps d and e above.
CAUTION
Be sure gasket seats on the filter and cap are clean before installing gaskets and caps.
o.
Install gasket (9) with beaded side toward media filter. Install cap (8) and clamp (7).
p.
Install gasket (5), cap (4) and clamp (3).
q.
Close drain valve (2).
r.
Close vent valve (1).
4-221
