TM 10-4610-232-12
Figure 4-71. Fuel Lines
(1) Remove nut (4) and washer (5). Remove bulkhead fitting assembly (3).
(2) If necessary, remove flare tube fittings (2 and 6).
(3) Remove cap (7) by removing capscrew (8). lockwasher (9), washer (10) and nut (11).
(4) Remove lines (12) from fuel pump fittings (13).
(5) Remove fuel lines from fitting (14) at heater.
(6) Cut and remove tie wraps (para. 4-10). Remove fuel lines.
REPAIR - FUEL LINES.
I
a. Repair damaged or unserviceable components by replacement.
b. Replace damaged fuel lines.
INSTALLATION - FUEL LINES.
a. Place fuel lines into position and secure fitting (14) at heater connector end.
b. Connect fuel line end (12) onto fitting (13) at fuel pumps.
c. Position/dress fuel lines and secure with tie wraps (para. 4-10).
d. Secure cap (7) with capscrew (8). lockwasher (9) washer (10) and nut (11).
e. If removed, install flare fittings (2 and 6) into bulkhead fitting (3).
f. Install bulkhead fitting (3) through wall of ROWPU and secure with washer (5) and nut (4).
g. Fasten line (1) to fitting (2).
4-249
