TM 10-4610-232-12
k. Frame structure (57).
(1) Remove capscrews (48), Iockwashers (49) and washers (50).
(2) Lift frame assembly out of position.
l. Remove capscrews (52), Iockwashers (53), washers (54), locknut (55), vibration pads (56) and remove support bar
(51).
a.
b.
c.
Replacement of unserviceable parts.
Straightening of bent or cracked metal.
Clean and paint as needed.
REASSEMBLY.
a. Place frame (57) into position and support.
(1) Install and secure washers (50), Iockwashers (49) and capscrews (48).
(2) If bar (51) was removed, place bar (51) and vibration pads (56) in position and secure with locknut (55), washers
(54). Iockwashers (53) and capscrews (52).
b. Install and secure tie down brackets (46) and rivets (45) in place (para. 4-10).
c. Position adjusting plate (44). Install and secure capscrews (43), Iockwashers (41), washers (42) and nuts (40).
d. Place leg (39) into position. Install and secure capscrews (38), washers (37), Iockwashers (36) and nuts (35).
e. Install hook bolts (47) and place RO element removal rods and hanger straps (34) in position. Secure with locknuts
(32) and washers (33).
f. Line up frame hole to control panel tab, Secure with bolt (31), washer (30) and nut (29).
g. Install hanger wire (28). Secure with bolt (27), flat washer (26A), fender washer (26) and locknut.
h. Place panel (18) into position. Secure by installing screws (24).
(1) Place tie down brackets (23) in position.
(2) Install and secure capscrews (22), washers (21), Iockwashers (20) and nuts (19).
i. Place panel(13) onto frame. Install and secure with capscrews (17), Iockwashers (15), washers (16) and nuts (14).
j. Place panel(11 ) onto frame. Install and secure with screws (12).
k. Place filter gate (9) into position and secure by installing retaining pin (10).
l. Hold channel brace (5) in position. Secure by installing capscrews (6), Iockwashers (7) and washers (8).
k. Place divider panel in position. Secure by installing capscrews (4), washers (3), Iockwashers (2) and nuts(1).
4-272 Change 2
