TM 10-4610-239-10
TM 08580B-10/1
a.
Installation.
(1)
Remove pin (1) from panel face (2).
(2)
Position top of meter (3) Inside of upper bracket on panel face.
(3)
Slide meter to left and engage bottom of meter In slot of lower bracket.
(4)
Continue to slide meter to left until meter Is fully engaged. Secure meter by positioning pin (1) through
hole in bottom of meter and hole In panel face.
(5)
Remove protective cover (4) from terminal marked TDS MONITOR POWER and TDS MONITOR
SENSOR located on panel face.
(6)
Remove protective covers (5) from cable (9) and attach connector (6) to terminal marked TDS
MONITOR POWER.
(7)
Remove protective covers (5) from cable (7) and attach connector (8) to terminal marked TDS
MONITOR SENSOR.
b.
Removal.
(1)
Disconnect cable (9) from terminal marked TDS MONITOR POWER and attach protective cover (5) to
connector (6).
(2)
Disconnect cable (7) from terminal marked TDS MONITOR SENSOR and attach protective cover (5) to
connector (8).
(3)
Remove pin (1) from bottom of panel face and slide meter (3) to right until bottom of meter clears bottom
of bracket.
(4)
Lift meter (3) from panel face.
(5)
Attach protective covers (4) to two terminal connectors.
(6)
Install pin (1) to panel face.
2-15