TM 10-4610-241-24
TO 40W4-13-42
2-63.
CARTRIDGE FILTER REPAIR - continued.
b.
Cleaning.
(1) Wash parts with detergent and clean, fresh water.
(2) Rinse parts with clean water and dry with wiping rag.
c.
Inspection.
(1) Inspect shell (41) for cracks, deep scratches, and delamination.
(2) Inspect packing seat in shell (41) for particles of dirt, cracks, and delamination.
d.
Repair.
Replace defective components.
e.
Assembly.
(1) Apply adhesive to surface of gasket (36) to be in contact with strap (35) and position on inside of strap.
(2) Position strap (35) on filter and secure to ROWPU frame with two screws (33), flatwashers (34), lockwashers
(32) and nuts (31).
(3) Apply adhesive to surface of gasket (30) to be in contact with bracket (29) and position on bracket.
(4) Position bracket (29) on unit and install two screws (28), flatwashers (27 and 26), lockwashers (25) and nuts
(24). Push bracket against filter shell (41) and tighten nuts (24).
(5) Position bracket (23) on filter, below top rim as marked at disassembly. Secure with two screws (21),
washers (22), lockwashers (20) and nuts (19).
NOTE
Be sure to wrap tape in same direction as threads.
(6)
Apply anti-seize tape to threads of all male fittings.
(7)
Lubricate gasket (15) and position on adapter (14), then install adapter on filter shell (41).
(8)
Slide gasket (15) over pipe joint and install clamps (13), bolts (12) and nuts (11).
(9)
Install nipple (10) on filter shell (41) and connect elbow (9) to nipple. Then install nipple (8) on elbow (9).
2-248
