TM 10-4610-241-24
TO 40W4-13-42
2-65. BELT GUARD REPLACE (MODELS WPES-10, WPES-20, and WPES30).
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools Required
General Mechanics Tool Kit (Appendix B, Section III, Item 4)
Materials/Parts Required
Lockwashers (TM 10-4610-241-24P
Equipment Condition
Reference
Power shutdown (Power Source Manual).
a.
Removal.
(1)
(2)
(3)
(4)
(5)
Remove six screws (1), lockwashers (2) and belt guard (3) from belt shroud (7).
Remove six nuts (4), lockwashers (5) and flat washers (6).
Remove belt shroud (7) from mounting plates (10).
As required, remove screws (8), lockwashers (9) and plates (10).
If removal of studs (11) is required, position heads of studs ( 11) between the partially open jaws of a vise
and beat out studs with a hammer as illustrated.
b.
Installation.
(1)
If removed, install studs on plate (10) with a hammer and vise as illustrated.
(2)
Position mounting plates (10) on ROWPU floor and secure with six lockwashers (9) and screws (8).
(2)
Position belt shroud (7) over studs (11) on mounting plates (10).
(3)
Install six flat washers (6), lockwashers (5). and nuts (4).
(4)
Position belt guard (3) on belt shroud (7).
(5)
Install six lo&washers (2) and screws (1).
2-254 Change 1
