TM 10-4610-241-24
TO 40W4-13-42
2-80. LIGHT ASSEMBLY REPAIR (WPES-10 AND H-9518-1).
This task consists of:
a. Removal
d. Inspection
g. Installation
b. Disassembly
c. Cleaning
e. Repair
f. Assembly
INITIAL SET-UP:
Tools Required
General Mechanics Tool Kit (Appendix B, Section III, Item 4)
Material/Parts Required
Rags, Wiping (Appendix C, Section II, Item 14)
Detergent (Appendix C, Section II, Item 5)
Sandpaper (Appendix C, Section II, Item 16)
Lo&washers, Grommets and Packing (TM 10-46l0-241-24P)
Equipment Condition
Reference
Power shut down (Generator Manual).
Electrical Cable Assembly disconnected from Towing vehicle (TM 10-4610-241-10).
NOTE
Repair at light assembly can be performed while light is installed on trailer. Go to
Disassembly procedure if repair only is required.
a.
Removal.
NOTE
•
There are two light assemblies on the flatbed cargo trailer. Both are removed the
same. One is shown, the other is similar.
•
Tagging wires before removal, noting their connection points will facilitate
installation. Be sure to transfer tags to replacement parts before discarding or
turning defective parts in to Supply.
(1)
Tag all wires to be disconnected.
(2)
Pull four connectors (1) from spring clips (2).
(3)
Separate two halves of four connectors (1),
(4)
Work grommet (3) out of hole in trailer frame (5).
(5)
Pull cable (4) out through hole in trailer frame (5). Grommets will fall off as cable is pulled out.
(6)
Support light assembly (8) and remove two screws (6), lo&washers (7) and light assembly (8).
2-312 Change 1
