TM 10-4610-241-24
TO 40W4-13-42
2-83. AIRBRAKE INSTALLATION REPLACE (MODELS WPES-10 AND H-9518-1) - continued.
(17)
Remove nuts (30) from loop clamps (31).
(18)
Open loop clamps (31) and remove from studs (32) and tubes and hoses to which they are attached.
NOTE
Tagging hoses and tubes, indicating their connection points will facilitate installation. Be
sure to transfer tags to replacement parts, if defective parts are discarded or turned in to
SUPPlY .
(19)
Tag and unscrew tubing (33) from tee (34) and remove tees.
(20)
Tag and disconnect opposite end of tubing (33) and remove tubing.
(21)
Tag and unscrew hoses (35 and 36).
b.
Installation.
NOTE
l
The following procedures describe installation of airbrake components used
throughout the brake system. Installation of one of each type part is shown.
Installation of other like parts is similar.
l
Be sure to wrap tape in same direction as pipe thread.
(1)
Apply anti-seize tape to male threads of fittings.
(2)
Position and connect hoses (36 and 35) as tagged during removal.
(3)
Position tubing (33) on trailer and connect to tees (34) and other components as taged during removal.
(4)
Position loop clamps (31) around hoses and tubes and position on studs (32).
(5)
Install nuts (30).
2-330 Change 1
