TM 10-4610-241-24
TO 40W4-13-42
2-87. AXLE ASSEMBLY (HUB AND DRUM) REPLACE (WPES-10 AND H-9518-1) - contimed.
(5)
Install inner bearing cone (11) and seal (12) on hub and drum assembly (15).
(6)
Position hub and drum assembly (15) on spindle ( 16).
(7)
Position outer bearing cone (10) in bearing cup (13).
(8)
Install key washer (9) and inner spindle nut (7). Tighten inner spindle nut ringertight.
(9)
Go to Adjust procedure below to complete installation.
f.
Adjust.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
If removed, install wheel and tire assembly (TM 10-4610-241-10).
Spin wheel and tire assembly and tighten inner spindle nut (7) until wheel starts to bind.
Loosen inner spindle nut (7) one flat, or until wheel assembly doesn’t bind.
Put one hand on bottom and one hand on top of tire. Push with one hand and pull with other hand. Tire
and wheel assembly should not move.
If tire and wheel assembly moves, repeat steps (2) thru (4).
Install tabwasher (6).
Bend one tab of tabwasher (6) over one flat of inner spindle nut (7).
Install outer spindle nut (5).
Bend one tab of tabwasher (6) over one flat of outer spindle nut (5).
Install gasket (4), hubcap (3), six lockwashers (2), and bolts (1).
2-352 Change 1
