TM 10-4610-241-24
TO 40W4-13-42
3-30. CABLE ASSEMBLY, W56 (TDS POWER) REPAIR - continued.
b.
Cleaning.
Clean cable assembly and mounting hardware with damp rags.
c.
Inspection.
For inspection procedures, refer to TM 43-0158/TO 1-1A-15 (Air Force).
d.
Test.
Test cable assembly for continuity and shorts, using cable wiring schematic (opposite page) as a guide.
e.
Repair.
1.
Replace lockwashers and other parts if unserviceable.
2.
For repair procedures, refer to TM 43-0158/TO 1-lA-15 (Air Force).
f.
Installation.
(1)
Position nut (9), seal ring (8), seal (7), adapter (6) and gasket (5) on cable assembly (10).
(2)
Feed cable lugs (2) thru cutout in wall of junction box and pull thru to reach terminal board, TB4 (3).
(3)
Install nut (4) to secure adapter (6) to junction box (11).
(4)
Connect three wire lugs (2) to terminal board TB4 with screws (1) as follows:
Black Wire
TB4-1
White Wire
TB4-2
Green Wire
TB4-3
(5)
Position seal (7) inside adapter (6) and seal ring (8) on inside of nut (9) and connect nut to adapter, making
sure cable wires injunction box have enough slack to prevent tension on wires.
(6)
Position gasket (22) on end of connector jack (21).
(7)
From back side of control panel (23), position connector (21) in cutout on control panel (23).
(8)
Install cable cap (16), four screws (15), washers (14), lockwashers (13) and nuts (12) to secure cable
assembly to control panel (23).
(9)
Secure cable assembly (10) to back of control panel (23) with clamp (20), screw (19), lockwasher (18) and
nut (17).
3-182
