SECTION A
(1) UNPACKING INSTRUCTIONS:
This unit comes packed upright in a corrugated carton.
Lift the back unit condenser from the carton first and
place on a firm level bench.
Lift the heater section from
the carton.
Position the heater unit on the condenser by
lifting the heater and placing the unit on the protruding
hangers welded on the condenser.
Remove all tie-downs
and crumpled paper from the condenser section.
Unpack
the styrofoam wrappings from around the heater section
and generally clean all wrappings from the units.
Unpack
the 1¼ inch and 2 inch secondary flask supports and the
wooden graduated cylinder support and place in a safe
location.
(2) ASSEMBLY INSTRUCTIONS:
(A) Position the heater plate to lay flat on the
adjustable elevator plate.
(B) Plug the line cord into a properly fused and
grounded receptacle of the correct voltage, as marked on
the information plate.
(C) Adjust the front leg on the heater unit to level
the apparatus if the table is uneven.
(D) Fill
Method D86.
the condenser unit in accordance with ASTM
(E) Attach the small connector cable coming from the
heater unit to the connector on the bottom of the condenser
unit.
A1 of 2
