TM 10-6630-246-12&P
TM 09241B-12&P
d.
Column 4. Maintenance Level. Column 4 specifies each level of maintenance authorized to perform each
function listed in column 3, by indicating work time required (expressed as man-hours in whole hours or decimals) in the
appropriate subcolumn. This work-time figure represents the active time required to perform that maintenance function at
the indicated level of maintenance. If the number or complexity of the tasks within the listed maintenance function vary at
different maintenance levels, appropriate work-time figures are to be shown for each level. The work-time figure
represents the average time required to restore an item (assembly, subassembly, component, module, end item, or
system) to a serviceable condition under typical field operating conditions. This time includes preparation time (including
any necessary disassembly/assembly time), troubleshooting/fault location time, and quality assurance time in addition to
the time required to perform the specific tasks identified for the maintenance functions authorized in the maintenance
allocation chart. The symbol designations for the various maintenance levels are as follows:
C ........................................................................................Operator or Crew Maintenance
O........................................................................................Unit Maintenance
F ........................................................................................Direct Support Maintenance
H ........................................................................................General Support Maintenance
D ........................................................................................Depot Maintenance
e.
Column 5. Tools and Test Equipment Reference Code. Column 5 specifies, by code, those common tools
sets (not individual tools), common TMDE, and special tools, special TMDE, and special support equipment required to
perform the designated function. Codes are keyed to tools and test equipment in section III.
f.
Column 6. Remarks. When applicable, this column contains a letter code, in alphabetical order, which is
keyed to the remarks contained in Section IV.
B-4.
EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS, SECTION III.
a.
Column 1. Reference Code. The tool and test equipment reference code correlates with a code used in the
MAC, Section II, Column 5.
b.
Column 2. Maintenance Level. The lowest level of maintenance authorized to use the tool or test equipment.
c.
Column 3. Nomenclature. Name or identification of the tool or test equipment.
d.
Column 4. National Stock Number. The National stock number of the tool or test equipment.
e.
Column 5. Tool Number. The manufacturers part number or type number.
B-5.
EXPLANATION OF COLUMNS IN REMARKS, SECTION IV.
a.
Column 1. Remarks Code. The code recorded in column 6, Section II.
b.
Column 2. Remarks. This column lists information pertinent to the maintenance function being performed as
indicated in the MAC, Section II.
B-3
